AUTHORS: Yedilkhan Amirgaliyev, Murat Kunelbayev, Aliya Kalizhanova, Beibut Amirgaliyev, Ainur Kozbakova, Omirlan Auelbekov, Nazbek Kataev

Download as PDF

ABSTRACT: The paper herein considers the study of convective heat transfer in flat plate solar collectors, as it is seen from the analysis on research of the heat transfer by a circular and flat tubes upon conforming the forced and free convections, placed vertically or horizontally with various liquid flow directions. There have been obtained Nusselt criterion dependencies in circular and flat pipes, which shows that corresponding equations allow defining the heat transfer intensity for all fluids with appropriate accuracy. As well there has been studied Prandtl criterion for fluids, which plays an important role in points spacing as regard to the curve. In each case the lines are with a tip 1/3, as in the research herein only the laminar conditions have been considered

KEYWORDS: - Flat plate solar collector, convection, convective heat transfer, solar radiation

REFERENCES:

[1]M. Rebay, A. Arfaoui, G. Mebarki, R. Ben Maad, and J. Padet, Improvement of the Pulsed photothermal technique for the measurement of the convective heat transfer coefficient, Journal of Thermal Science, Vol. 19, pp. 357-363, (2010)

[2]P. R. Kanna, and M. K. Das, Conjugate forced convection heat transfer from a flat plate by laminar plane wall jet flow, International Journal of Heat and Mass Transfer, Vol. 48, pp. 2896- 2910, (2005)

[3]A. Pozzi, and R. Tognaccini, Conjugated heat transfer in unsteady channel flows, International Journal of Heat and Mass Transfer, Vol. 54, pp. 4019-4027, (2011)

[4]Z. G. Liu, S. Q. Liang, and M. Takei, Experimental study on forced convective heat transfer characteristics in quartz microtube, International Journal of Thermal Science, Vol. 46, 139-148, (2007)

[5]Celata, M. Cumo, V. Marconi, S.J. McPhail, and G. Zummo, Microtube liquid single-phase heat transfer in laminar flow, International Journal of Heat and Mass Transfer, Vol. 49, pp. 3538-3546, (2006)

[6]G. L. Morini, Viscous heating in liquid flows in micro-channels, International Journal of Heat and Mass Transfer, Vol. 48, pp. 3637-3647, (2005)

[7]C. Nonino, S. Savino, S. Del Giudice, and L. Mansutti, Conjugate forced convection and heat conduction in circular microchannels, International Journal of Heat and Fluid Flow, Vol. 30, pp. 823-830, (2009)

[8]J. Y. Jang, and Y. W. Chiu, 3-D Transient conjugated heat transfer and fluid flow analysis for the cooling process of sintered bed, Applied Thermal Engineering, Vol. 29, pp. 2895-2903, (2009)

[9]A. Barletta, E. Rossi di Schio, G. Comini, and P. D’Agaro, Conjugate forced convection heat transfer in a plane channel: Longitudinally periodic regime. International Journal of Thermal Science, Vol. 47, pp. 43-51, (2008)

[10] A. Ates, S. Darıcı, and S. Bilir, Unsteady conjugated heat transfer in thick walled pipes involving two-dimensional wall and axial fluid conduction with uniform heat flux boundary condition, International Journal of Heat and Mass Transfer, Vol. 53, pp. 5058-5064, (2010)

[11] B.A. Abu-Hijleh, M. A. Al-Nimr, and M. A. Hader, Thermal equilibrium in transient conjugated forced convection channel flow, Numerical Heat Transfer A, Vol. 43, pp. 327- 339, (2003)

[12] L. He, and M. L. G. Oldfield, Unsteady conjugate heat transfer modeling, Journal of Turbomachinery, Vol. 133, pp. doi:10.1115- 1.4001245, (2011)

[13] M. Rebay, M. Lachi, and J. Padet, Measurement of the convective heat coefficients by the pulsed method—influence of the boundary layer perturbation, International Journal of Thermal Sciences, Vol. 41, pp. 1161- 1175, (2002)

[14] M. Rebay, and J. Padet, Parametric study of unsteady forced convection with pressure gradient, International Journal of Engineering Science, Vol. 43, pp. 655-667, (2005)

[15] M. Rebay, J. Padet, and S. Kakac, Forced convection from a microstructure on a flat plate, Heat and Mass Transfer, Vol. 43, pp. 309-317, (2007)

[16] E. C. Mladin, D. Stanciu, and J. Padet, Transient thermal coupling for flows over a finite thickness plate exposed to a time-dependent temperature, Proceedings of the Romanian academy, Vol. 11, pp. 163-170, (2010)